M10 PRO-BYS Block Yard System

For high block production at a blockyard

From
R 908 500.00

The all-new M10-PRO is the ultimate addition to any blockyard. The M10-PRO is equipped with a double chamber for even higher block production – offering greater returns on your investment. Hydraform’s M10-PRO requires as few as 8 to 10 operators and is a smart choice when looking to lower expenses and increase margins. The three-phase power source increases the convenience and usability of this incredible machine.

Double Chamber Production

300L Pan Mixer

200 Litre air compressor

Hydraulic Power Rack

12 Months Machine Warranty

Free mould included in machine chamber

Training Available

±8-10 Operating Staff

Machine weight: ±800kg (excl. crating)

HYDRAFORM STANDARD 220MM INTERLOCKING BLOCK

This block is used to build load bearing walls using mortar in the super structure, by dry-stacking the blocks on each other in the wall. This block is used for all wall construction in housing and walling. This block will be perfect for ground + 1 construction.

HYDRAFORM STANDARD 180MM INTERLOCKING BLOCK

This 180mm wide, dry-stacking block is used in the construction of load bearing walls for single storey structures only. This block can be used on the first floor of double-storey structures, so as to reduce the weight, but cannot be used in the construction of the ground floor of a double storey structure. The 180mm block uses 20% less material than the 220mm block.

HYDRAFORM STANDARD 150MM INTERLOCKING BLOCK

This 150mm wide, dry-stacking block is used in the construction of non-load bearing walls for internal walls providing a ring beam is used. This block can be used in the construction of multi-storey structures as an in-fill wall panel between concrete pillars or steel columns. The 150mm block uses 30% less material than the 220mm block.

HYDRAFORM STANDARD 140MM SEMI-INTERLOCKING BLOCK

This 140mm wide block is semi dry-stacking, and a wet cement slurry is poured between the two vertical joints of the blocks. This block is used for internal wall construction and as an in-fill wall panel between concrete pillars or steel columns. The 140mm block uses 36% less material than the 220mm block.

HYDRAFORM LONG BLOCK FOR CORNER CONSTRUCTION

This block is made on any of the Standard Hydraform moulds by double filling the block compression chamber, if the material allows. The long block is used for corner construction and replaces the need for a half block. The daily production of long blocks must be 10% of the daily production of standard blocks.

HYDRAFORM CONDUIT 220MM INTERLOCKING BLOCK

This 220mm wide, dry-stacking block is used to lay the electrical conduit horizontally within the wall structure so that minimal wall chasing is required. This block can also be used in seismic areas (as per engineer’s design) to lay steel re-bar within the wall structure to strengthen the stucture but also allow enough flexibility to resist collapse during an earthquake.

HYDRAFORM CAPPING 220MM BLOCK

This 220mm wide, dry-stacking block is used for capping of boundary walls and for window sills.

Up to 6000 blocks per day (8 hour shift)

Power source : Electric Three Phase 380V – 250kw

Semi Automated Hydraform Blockmaking Plant, pneumatic Loader inclusive of a 200l air compressor, 2 conveyors for material movement.

Optional: Rotary screen and single conveyor For material segmentation

Enquiry Form


    Related Products

    If it looks right, it might not work right… the crippling cost of fake equipment.

    We’ve all been faced with this situation before. You need equipment or a spares part, you’re a bit low on cash…and it becomes very tempting to take the easier, ‘cheaper’ route and get non-original parts. You save time, and money… right? Wrong!